Condux – 08782000 – Gulfstream™ 400

  • Able to blow fiber cable long distances
  • Very fast
  • Sensors front and rear to protect your cable through install
  • Total control of your fiber installation
  • Portable, everything goes in the job box
  • Easy to install cables into rollers
  • Superior service and support
Clear

Description

The Condux Gulfstream 400™ Fiber Optic Cable Blower is designed for the installation of fiber optic cables with diameters from 0.23″ (5.8 mm) to 1.13″ (28.7 mm) into microduct.

Order Duct and Cable Packs separately, to ensure the correct size for your needs.

The Condux Gulfstream™ 400 Fiber Optic Cable Blower is ideal for “Last Mile” Fiber Installations.

Install up to  300   feet of fiber optic cable per minute (90 m/min).  The cable travels at the same speed as the air! A carrier is always attached to the front of the cable. Compressed air propels the carrier and cable through the air-tight sealed duct. And, because airflow and tractor drive speed can be adjusted, you can install fiber at the rate which best suits any application.

The Condux Gulfstream 400  Deluxe  Fiber  Optic  Cable Blower features a longer tractor feed grip area for less stress on the cable and a  manual cylinder on the tractor feed to better control down pressure. Condux’s patented traction control system shuts down the blower when problems with cable slippage or duct blockage are detected, adding safety to every job and preventing costly cable damage.

Convenient tilting of the Condux Gulfstream 400 Deluxe Fiber Optic Cable Blower for ease of pouring in lubricant. Easily install the cable into rollers, then close and you are ready to start.

The  Condux  Gulfstream  400  Deluxe Fiber Optic Cable Blower is extremely easy to handle and transport. The blower and all accessories including hydraulic hoses, cable and conduit packs, and seal kits conveniently fit into a lightweight job box with wheels.

Can be ordered with or without the Electronic Control Box (ECB). The ECB monitors and displays the cable and tractor drive speeds and will automatically shut off the blower in these conditions: Over pressure limit, slippage, over-speed, and cable stoppage.

Cable  Packs:  include Cable Grips (for end of cable), Pneumatic Venturies, and Cable Seals.

Duct Packs: include Cable Grip (for end of inner-duct), Cable Carrier, Innerduct Clamps, Innerduct Seals, Innerduct Pulling Eye & Foam Carriers.

Features

  • Speed and distance counter LCD read-out
  • Hinged air block and conduit clamps
  • Smooth and quiet belt tractor
  • Convenient tilt capability allows ease of pouring in lubricant

Key Facts

  • Duct OD: 1/2″-2″ (10-51mm)
  • Fibre Cable OD: 0.23″-1.13″ (5.8-28.7mm)
  • Average Distance~: 6,500ft
  • Max Speed: 300ft/min
  • Weight: 104lbs
  • Push Force: 0-180lbs (778 N)
  • Air Pressure Requirements (PSI)*:  100-130 PSI
  • Air Pressure Requirements (BAR)*: 10-14 Bar
  • Flow Requirements (CFM)*: 185-500 CFM
  • Flow Requirements (CMM)*: 5-14 CMM
    ~Dependent on duct installation, integrity, and size of fiber and duct
    *Air pressure and flow requirements depend on the size of the duct and the size of fiber being installed into that duct.

Condux will provide full training, theory, and practical use of their equipment.

Please call 800-423-2594 for more information.

Additional information

Manufacturer

Condux

Compressor

with, without